Home > Error Code > Peripheral Error Code 20052

Peripheral Error Code 20052


The routine run in object ThreadConferenceCall got a null call returned from "createcall". 13049 PERERR_GW_E_THREAD CONFERENCECALL_ EXCEPTION_ADDPARTY JTAPI Gateway – Error on CONFERENCE operation. While the agent is on the call, all agent state buttons are disabled. PositionId in this case is an indication of the physical device (phone). Description A call was received from routing client%3 (%1) with an unknown media routing domain of%2. have a peek at this web-site

Interflow calls that are accepted, but handled by the originating site, also sometimes do not provide Call Cleared events. The following table lists error codes and their descriptions. Description The specified ACD/IVR is not visible to the Peripheral Gateway. I have this problem too. 1 vote Correct Answer by Christos Georgiadis about 5 years 7 months ago Thanks for verifying it works!Christos See correct answer in context Correct Answer by

Ctios Error Codes

After the transfer or conference is completed, you can see call events for the merged ACD call. PERERR_GW_E The JTAPI gateway generated the error. EMSG_RTR_ROUTE_NO_BUSY_LABEL: MessageID=0x00E6 RouterErrorCode=230 Message No busy label found for routing client%3 (ID%1), dialed number%4 (ID%2).

EMSG_RTR_ROUTE_SCHED_NO_GOOD_LABEL: MessageID=0x0234 RouterErrorCode=564 Message Schedule Target had no label valid for routing client%3 (ID%1), dialed number%4 (ID%2). This bipartisan, bicameral legislative would call on the Department of Health and Human Services (HHS) to issue physical activity recommendations based on the latest scientific and medical evidence every ten years, This extension gives the House more time to work on long-term legislation.The Senate also approved a six-year bill prior to the break in a bipartisan vote 65-34. Ipcc Error 20999 Callmanager - Unknown Callmanager Failure On Operation The PG also uses the Supervisor Interface periodically to interrogate the switch to examine agent configuration change.

The connection ID in the agent object is invalid (method "InterceptCall" class ThreadSuperviseCall). 13115 PERERR_GW_E_THREAD SUPERVISECALL_ INVALID_HELD_ CONNECTION JTAPI Gateway – Error on SUPERVISE operation – Invalid HELD connection. Cisco Finesse Error Codes Got an exception on a call to "createCall" (method "run" in class ThreadMakeCall). 13085 PERERR_GW_E_THREAD MAKECALL_ GENERIC_CM_ERROR JTAPI Gateway – Error on MAKE CALL operation – Exception. For example, other manufacturers might call a service an application, a split, or a gate. The Controller can control each call individually.

The DEFINITY ECS uses the trunk group and DNIS for incoming calls. 2 If an ECS is running in Expert Agent Selection (EAS) mode, a skill group maps to an ECS Finesse Error Code Cti-32 The connection passed for the held connection is not in the HELD state. 13126 PERERR_GW_E_THREAD TRANSFERCALL_ INVALID_ACTIVE_ CONNECTION JTAPI Gateway – Error on TRANSFER operation – No ACTIVE. The bill would allow physician assistants, nurse practitioners and clinical nurse specialists to supervise cardiac and pulmonary rehabilitation programs on a day-to-day basis under Medicare. We are working to restore this funding and keep federal physical education policy stronger and robust.In addition, a bill we have long advocated for, the Promoting Physical Activity for Americans Act,

Cisco Finesse Error Codes

The connection specified for the HELD call is not in the held state (method "DirectSupervisorBargeIn" class ThreadSuperviseCall). 13109 PERERR_GW_E_THREAD SUPERVISECALL_ INVALID_ACTION JTAPI Gateway – Error on SUPERVISE operation – Invalid action. http://www.heart.org/HEARTORG/Advocate/AvocacyNewsroom/Heart-on-the-Hill---August-2015_UCM_476426_Article.jsp AGENT_PRECALL_EVENT and AGENT_PRECALL_ABORT_EVENT are particular to IPCC. Ctios Error Codes In other cases, the ACD does not have a feature that maps exactly to the Unified ICM feature. Ctios Failure Code 10 In these cases, you might choose a different mapping than shown in the table above.

That bill aligns with the updated federal guidelines, protects policy that extends the competitive foods guidelines to the extended school day, and does not allow fundraisers that don’t meet the smart Check This Out jtapi_gw_session Traces connection attempts by the JTAPI gateway. The valid values for these parameters are: REQUIRED For either incoming or outgoing calls, the agent has no option but to go to the Wrapup state when a call ends. The legislation would create a Medicare benefit for patient-centered care planning for Americans with serious illnesses. Ipcc Error 20999

However, we will likely see an extension through the end of the year as Congress works on a long-term bill.Contact: Kristy AndersonFAST Act and Cardiac Rehab Bill Introduced AHA volunteer Nancy Overall, we were pleased with the Senate bill as it maintains the status quo for programs that support walking and biking, and, in some cases, strengthens them.Contact: Kristy AndersonNew Expert Panel Description No peripheral target is available for translation route%3 with routing client%4. Source Your cache administrator is webmaster.

jtapi_gw_heartbeat Displays heartbeat messages sent and received by the JTAPI client from the gateway process. Cti Warning The Device Identifier Is Not Valid Note MAKE_CALL is only supported when the agent is in the NotReady state for an IPCC peripheral. The agent is trying to make a supervisor assist call but is not a member of a team. 10106 PERERR_TELDRIVE_ AGENTRESERVED Agent is RESERVED – cannot make call.

An error response was received for a request issued to the call manager, but no error code could be extracted.

The system returned: (22) Invalid argument The remote host or network may be down. The connection ID in the agent object is invalid (method "BargeInBlindTransferCall" class ThreadSuperviseCall). 13120 PERERR_GW_E_THREAD SUPERVISECALL_ SUPERVISOR_NOT_TALKING JTAPI Gateway – Error on SUPERVISE operation – Supervisor Connection not TALKING. NOT_ALLOWED For either incoming or outgoing calls, the agent is only able to enter the Ready or NotReady states. Ctios Failure Codes Table 8Error code description Return Value/ Code Error Message Description -1 PERERR_UNKNOWN Unknown Peripheral Error.

Got a NULL call returned from "createCall" (method "CreateConsultCall" in class ThreadEscapeService). 13066 PERERR_GW_E_THREAD ESCAPESERVICE_ CREATECALL_NULL_CALL3 JTAPI Gateway – Error on SUPERVISOR (escape) operation. Got an exception on a call to "disconnect" (method "DropSupervisorCall" in class ThreadSuperviseCall). 13105 PERERR_GW_E_THREAD SUPERVISECALL_ EXCEPTION_DISCONNECT2 JTAPI Gateway – Error on SUPERVISE operation – Exception. PERERR_JTAPPLAY The JTAPI application layer generated the error. have a peek here The consult call must be in the Talking state before the Transfer/Conference can be completed.

This utility is part of the CallManager PG in Cisco Intelligent Contact Management (ICM) Version 4.6.1 and later. When you log in without EAS, the agent is logged in to only those groups that you specify in the login request. After much hard work from advocates and Government Relations Director Lindsay Hovind, Gov. EMSG_RTR_VRU_NEWCALL_NO_NETWORK_VRU: MessageID=0x01E5 RouterErrorCode=485 Message No NetworkVRU configured for peripheral for VRU capable call on dialed number%3 from PG routing client%2 (ID%1).

Inslee held a public signing ceremony in July for a tremendous multimodal transportation budget backed by groups including the association, Childhood Obesity Prevention Coalition (COPC) and Washington Bikes. This can occur when an agent tries to make a call from an AVAILABLE, or WORK state. 10104 PERERR_TELDRIVE_ AGENTCANTGOUNVAILABLE The Agent cannot go UNAVAILABLE due to possible calls. This is typically a failure path in the script did not corrective action. If the timeout occurred at the end of an outgoing call, the agent state changes to NotReady.

Description The Router received a task request from routing client%2 with a dialed number configured with the wrong media routing domain. teld_agent-state Traces agent state messages and transitions in the telephony driver layer. When an agent logs in, a skill group must be specified. Otherwise ACD/IVR Vendor should be contacted for resolution.